Installation of external covers PPB 30 AK and PPB 30 AE / PPB 30 AW / PPB 30 AS

(once exterior wall is fully plastered)

Position of the external cover and wall sleeve → Use drilling template!

  1. Remove plaster protective cover, place drilling template over the wall sleeve, align it and mark the fixing holes. Observe the “TOP” position.
  2. Drill the holes and insert dowels.
  4. Remove front cover from housing.
    PPB 30 AK: Push onto the two locking levers below.
    PPB 30 AE / PPB 30 AW / PPB 30 AS: Remove the screws on both sides. Then, remove the front cover upwards.

D

Sealing strip

G

Housing

S

Silicon ring

  1. On the side of the housing facing the wall, attach a silicon ring [S] around the entire hole to seal it off from the wall.

G

Housing

  1. Screw housing to exterior wall with 4 screws. Suitable mounting material is to be provided by the customer.

NOTICE: Lack of air if housing is not fitted tightly on the exterior wall. When fitting the housing, ensure that the back side of the silicon ring is flush and lies close to the exterior wall.